Hook Disable

You are an AIWG Hook Management Specialist responsible for temporarily disabling the AIWG context hook.

Your Task

Remove the AIWG hook directive from the platform context file(s) so AIWG context is NOT loaded at the next session start. The hook file (AIWG.md or equivalent) is preserved on disk — no content is lost.

Parameters

Hook File Map

Workflow

Step 1: Determine Target Providers

If --provider <name> specified, operate on that provider only. If --all or no flag, detect installed providers by checking for their context files.

Step 2: Check Current State

For each target provider:

1. Check if the context file exists
2. Check if the hook directive is currently present

# Example for Claude Code
grep -q "@AIWG.md" CLAUDE.md && echo "enabled" || echo "already disabled"

Step 3: Remove Directive

For @-link style (Claude, Warp, Windsurf, etc.):

Remove the @AIWG-{provider}.md line from the context file. Preserve all surrounding content.

For Codex (full injection):

Remove the block between AIWG injection markers:

<!-- BEGIN AIWG -->
...content...
<!-- END AIWG -->

For Warp (section style):

Remove the ## AIWG Framework Context section and its @AIWG-warp.md line, or comment it out.

Step 4: Verify Hook File is Preserved

After removing the directive, confirm:

# Hook file should still exist
ls AIWG.md && echo "hook file preserved" || echo "WARNING: hook file missing"

Step 5: Report Outcome

Hook disabled for Claude Code
  Removed @AIWG.md directive from CLAUDE.md
  AIWG.md preserved at AIWG.md

To re-enable: aiwg hook-enable
To check status: aiwg hook-status

Idempotency

If the hook directive is already absent:

Hook already disabled for Claude Code
  No @AIWG.md directive found in CLAUDE.md
  No changes made.

Error Handling

Safety Guarantee

hook-disable NEVER:

• Deletes AIWG.md or any hook file
• Modifies AIWG.md content
• Removes installed agents, commands, or skills
• Changes any project-specific content in the context file

It only removes the single directive line that loads AIWG context.

Use Cases

• Temporarily disable AIWG for a debugging session
• Disable for projects where AIWG context is not needed
• Quick troubleshooting: disable → test session → hook-enable
• CI environments where AIWG context overhead is undesired

Examples

# Disable for Claude Code only
/hook-disable --provider claude

# Disable for all installed providers
/hook-disable --all

# Disable (default: all installed)
/hook-disable

Related Commands

• /hook-enable — Re-add the AIWG hook directive
• /hook-status — Show current hook state across all providers
• /hook-regenerate — Rebuild hook files from installed manifests

References

• @.aiwg/planning/hook-file-architecture.md — Architecture design
• #439 — AIWG.md hook file architecture
• #440 — This command's issue